Attached gable roof patio cover install#

Attach the roof felt to sheathing by using tacks, and ensure that they overlap about 3-4” at every edge.

Set the plywood sheathing to the roof trusses using 5/8” nails.Brace it for a while and repeat the step for the remaining roof trusses. Lift the end of roof trusses with someone’s help to the location according to your mark and set it by using nails. Put a mark on roof trusses’ locations, beginning from the shorter roof side, once every 24” in the center of lumbar pieces.Repeat the step for all of the support posts. Lift the lumbar pieces again and then set them securely. Now, detach the nails, put the 2 x 8 lumbar pieces down, and make holes on the support posts and 2 x 8 lumber pieces. Size and then put marks on suitable holes on beams and support holes to take in bolts in 5/8” size.Lift the 2 x 8 lumbar pieces with the help of someone else, and nail one of the 2 x 8 lumbar pieces temporarily to every side of the support post, but make sure the nails can be removed easily later on. Size and trim two lumber pieces in 2 x 8 that suits the distance between each support post.

Read also : Low Sloped Roof options to fit your need You need to ensure that the posts are upright by bracing them tentatively while securing the bolts and nuts.

Attached gable roof patio cover install#

Install the support posts on the anchors and set them loosely using bolts and nuts.

Size and trim support posts in 6 x 6 that suit the dimensions of the roof.

Arrange post anchors while the concrete hasn’t dried up yet. Set concrete in cylindrical shape within the hole and then cover with concrete.

On the ground, dig the holes for every post spot with a width of 12-18” and a depth of 18”.

Put a mark on the determined locations on the roof deck and the deck areas on the decided spots, so you can set a hole, concrete footing, and set the roof support posts.

Decide where the posts of roof support are going to be.